> In the case where TARS is on a circular orbit, the moment of release need not be precisely when v = v_targ, but rather can be at a specific orbital phase position instead.
My understanding is that it means it does not have to be precisely timed with regard to velocity, but has to be with regard to angle.
One timer could be used to launch multiple flywheel payloads over time
I am not sure that anything useful could survive that kind of sustained crushing acceleration. By comparison a rifle bullet being shot is around 100k Gs for millisecond , this would go on for weeks or months.
It's SpinLaunch from solar orbit rather than the surface of the Earth (in fact, they themselves say so at the end of 11.1). Even for the current tech demo of SpinLaunch, that was getting 10k G and the company found it wasn't too difficult to make payloads survive that: https://www.youtube.com/watch?v=g-DjBHroA1I
Yes, that's 10x-100x less than what you're asking (I've only skim-read the paper, your 100k-1M is certainly plausible given what they're focusing on is the "can it be done at all" and not a detailed launch proposal), but in practice if we were limited to 10k (we're probably not) that only means making the tether 10x-100x the length in this paper.
* My citation here is just "gut feeling" as I play around with ideas like this from time to time, and this particular thing, using electric forces for a non-gravitational orbit, was something I came up with and then rejected on this basis as part a hard-science tractor beam in the novel I've still not finished writing, and the accidental antimatter problem happened with relatively small accelerations for a plausible mass probe.
I’m very skeptical about Spinlaunch, but even if you can pour enough epoxy over something to allow it to survive 10k Gs for a few minutes, I am not sure you can scale it to 100k+ Gs for weeks, for a postage stamp sized payload that has to be almost perfectly flat - that just seems like a completely different problem domain.
I think the idea bears further investigation, but the omission from the paper feels a bit odd.
Good luck with the novel!
Please do watch the video I linked to — it was a surprise to the people whose cubesat design they lightly modified, that they didn't need to fill all voids with epoxy resin.
> I am not sure you can scale it to 100k+ Gs for weeks, for a postage stamp sized payload that has to be almost perfectly flat - that just seems like a completely different problem domain.
If anything, I expect "flat postage stamp" to be easier, even with a 100x increase in G-forces. Thin structure in compression -> total forces are still low. Balancing a fully laden lorry on a 10cm cube of steel (7.5kg vs 50 tons ~= 6,000x) seems borderline in the way that balancing a 10cm cube of steel on top of 1cm^2 of 80 gsm paper (=8mg vs 7.5kg ~= 937500) doesn't.
(Edit: forgot density of steel, thought it was 5 not 7.5)
> I think the idea bears further investigation, but the omission from the paper feels a bit odd.
100%. It does feel a bit like it's formalising my shower thoughts.
> Good luck with the novel!
Thanks, I'll need it! >_>
And even if you can find some magic superglue left in the tube to hold it there, it has to hang there for weeks: A cubist sword of Damocles.
But I think pouching the payload (presumably forming the structure around the payload) just translates the problem into holding a 8kg steel block to the ceiling with 1cm square of paper formed into a harness, and expecting it to hold for weeks.
Either way - hopefully it will be addressed in a follow-up
TAURUS: Torqued Accelerator Using Radiation Unleashed from the Sun.
Grammatically correct and it doesn’t drop a word just to mimic a sci-fi robot’s name in an incredibly awkward and stilted way. I like Interstellar as much as the next person, but that acronym felt like a stretch, and it leaves out (literally) useful information.
In 1887 Boys published this very entertaining article on how he produced long fine wires of quartz, by heating a small thread of glass (and other materials) with a blowpipe, such that it beads, the rod of glass was attached to a tiny dart on a crossbow beforehand, with a foot pedal to release the dart. When he released the dart right when the molten ball formed, the dart would shoot all through the hallway and 2 rooms before meeting a wall. The dart would stick in the wall and a continuous thread was formed between the crossbow and the dart on the end wall (about 90 feet or 30 meters away). When he switched to quartz he immediately observed that quartz took a much larger force, and hence decelerated the dart, so it wouldn't reach the other wall.
I wonder if quartz could be used for matching up Delta v for intercept missions.
Either way the first such probe should be called spiderman...
I cannot do justice for the style and presentation of this article, so you should read it for yourself:
echelon•6mo ago
https://www.youtube.com/watch?v=MDM1COWJ2Hc
idiotsecant•6mo ago
hersko•6mo ago
mperham•6mo ago
chii•6mo ago
Science and education channels upload quite infrequently and irregularly (but each video is very high quality), but even if it is shared, it "drops off" as people finish watching it and move on.
And unfortunately, this sort of content just does not beat those clickbait slop that tends to get shared. I try to correct it often by sharing these videos myself, but alas i dont think my drop in the bucket makes much difference.