Can anyone elaborate on this? How does a single receiver produce multiple concurrent outputs, and how are they isolated in this context?
Think of any antenna: it is just a rod or a coil, it may have a specific frequency that it particularly likes because that is a nice fraction of its wavelength or close to its own resonance frequency, but that doesn't mean it isn't going to receive all the other signals to greater or lesser extent as well. The ratio between that one that it likes and the rest is called selectivity. The lower the selectivity the more evenly you will receive all signals at the same time.
Usually receivers have a tuned front-end to get as much of the signal you want and to repress the rest as much as possible but that is optional, you can have a wideband front end just the same.
The abstract of the paper:
Coupling a Rydberg vapour medium to both microwave and optical fields enables the benefits of all-optical detection, such as minimal disturbance of the measured field and resilience to very strong signals, since no conventional antenna is required. However, peak sensitivity typically relies on adding a microwave local oscillator, which compromises the all-optical nature of the measurement. Here we introduce an alternative, optical-bias detection, that maintains fully optical operation while achieving high sensitivity. To address laser phase noise, which is critical in this approach, we perform a simultaneous measurement of the noise using a nonlinear process and correct it in real time via data processing. This yields a 35 dB improvement in signal-to-noise ratio compared with the basic method. We demonstrate a sensitivity of 176 nV / cm / sqrt(f Hz) , reliable operation up to 3.5 mV/cm at 13.9 GHz, and quadrature-amplitude modulated data transmission, underlining the ability to detect microwave field quadratures while preserving the unique advantages of all-optical detection.
Emph. mine, at about -36 dBm that's not super sensitive yet though.
boznz•1d ago
Neywiny•1d ago
boznz•1d ago
Neywiny•1d ago